HT250 Adjustable Retention Test Tool

TOOL SET UP

1. Tool part number designates tool body only, without tip. Refer to Chart A for preset range of tool.

2. Remove button head (shipping) screw. Select appropriate tip and screw into tool body through slide.

TOOL ADJUSTMENT

1. Remove hand protector, back off lock nut away from body of tool to allow free movement of adjustment screw.

2. Secure tool in a suitable fixture with force gage, or hold firmly by hand and apply axial force until end of slide is aligned with indicator mark. Note reading of force on gage (or accurate weight-scale).

3. Adjust tool to required force by turning adjustment screw with a screwdriver, clockwise to increase force and counterclockwise to decrease force. When required value is achieved, tighten lock nut firmly while maintaining alignment of slide and indicator line. Tool is now set.

4. Note: Inspection stickers may be used to seal hand protector onto tool body, in order to signal any tampering with the adjustment screw.

USE OF TOOL (for 210, 240 and 250 tool series)

1. To test retention of socket contacts, use socket tester tip with preset tool. Insert tester (pin) into mating end of contact. Tool must be in a straight line with contact. For pin contacts, fit pin tester to tool body and place over contact at the mating end.

2. Apply pressure toward contact until slide aligns with indicator mark, contact should remain firmly in place.

NOTE: ADDITIONAL TIPS ARE AVAILABLE.  PLEASE CONSULT ONE OF OUR CUSTOMER SERVICE REPRESENTATIVES.