Go/No Go Gages

Go/No Go Gages

It is important to periodically Gage the Crimp tool by using an Inspection/Verification Gage (Go/No-Go).  This step is performed to assure the tool has maintained the settings/tolerances it had when it was manufactured or calibrated. 

4/8 Indent tools can be easily gaged by selecting the correct Go/No-Go Gage, and following the directions on the gage, and tool instructions. 

Set the tool to the specified setting (Crimp Depth Selector) and first Insert the Go, then the No-Go end of the gage into the indenters.

The “GO” should pass freely between the four indenters, and the “NO-GO” may enter, but should not pass through the indenters.

View All Gages

View All Gage Sets